[NTLUG:Discuss] RedHat Server setup

m m llliiilll at hotmail.com
Mon Jan 6 08:38:51 CST 2003


>
>When your system boots, have you already hardcoded an address to eth1?
>For instance is it always 192.168.1.1?  Or, do you leave it disabled, and
>then the when the dhcp daemon startup up, it enables eth1 with an address.
>I guess I am trying to figure out if Linux or DHCP is in control of the 
>address.
>If Linux is in control, when I run the install, I will setup eth1 with a 
>specific
>address (say 192.168.1.1), but if the dhcpd daemon enables the card, then
>on my install I would tell Linux not to enable eth1.  I beleive I am 
>supposed
>to activate the card with a specific address.
>
assign an ip (hardcoded) on this machine and running a DHCP server on this 
machine, specify a range of ip (e.x. 192.168.1.100-192.168.1.200) for this 
DHCP server. have all other machines have dhcp client installed and refer 
this one as dhcp server.



>Thanks,
>Bob
>
>
>_______________________________________________
>https://ntlug.org/mailman/listinfo/discuss


_________________________________________________________________
The new MSN 8 is here: Try it free* for 2 months 
http://join.msn.com/?page=dept/dialup





More information about the Discuss mailing list