Linksys won't let Prism2 dirviers load! (was Re: [NTLUG:Discuss] Linux app as a wireless access point

[Richard Strittmatter]

only the older wpc11 cards are prism chipsets. I think version 3 and back.

Richard 

> -----Original Message-----
> From: discuss-bounces at ntlug.org 
> [mailto:discuss-bounces at ntlug.org] On Behalf Of Stephen Davidson
> Sent: Monday, January 05, 2004 12:55 PM
> To: NTLUG Discussion List
> Subject: Linksys won't let Prism2 dirviers load! (was Re: 
> [NTLUG:Discuss] Linux app as a wireless access point
> 
> Help!
> 
> I am trying to set up a network bridge via wireless using a 
> Linksys WPC11 card.
> However, I am not getting the modules to load.
> 
> When I checked, I found that Suse 8.2 had installed verision 
> 0.1.something of the Prism2 drivers.  So I went and got the 
> latest 0.2 drivers, and installed them.
> 
> The only symptom I get is during the module loading;
> /lib/modules/2.4.20-4GB/net/prism2_pci.o: init_module: No such device.
> 
> In the syslog;
> wland[2977] signal: terminating with signal 15
> 
> Suggestions?  If you can help, please call, as this is needed 
> to bypass a critical failure in a client's Internet Connection.
> 
> Otherwise, due to their apparent lack of support, I will have 
> to take this back to the store and get a different card 
> (recommendations appreciated).
> 
> Thanks and regards,
> Steve
> 
> --
> Java/J2EE Developer/Integrator
> Co-Chair, Dallas/FortWorth J2EE Sig
> 214-724-7741
> 
> 
> 
> _______________________________________________
> https://ntlug.org/mailman/listinfo/discuss
>