Linksys won't let Prism2 dirviers load! (was Re: [NTLUG:Discuss] Linux app as a wireless access point

[Jay Urish]

Dude,
Screw this...
Get a wep11 wireless bridge and be done with it. There is no reason to use 
hardware and software when a hardware solution is all you need.


At 12:54 PM 1/5/2004, you wrote:
>Help!
>
>I am trying to set up a network bridge via wireless using a Linksys WPC11 
>card.
>However, I am not getting the modules to load.
>
>When I checked, I found that Suse 8.2 had installed verision 0.1.something of
>the Prism2 drivers.  So I went and got the latest 0.2 drivers, and installed
>them.
>
>The only symptom I get is during the module loading;
>/lib/modules/2.4.20-4GB/net/prism2_pci.o: init_module: No such device.
>
>In the syslog;
>wland[2977] signal: terminating with signal 15
>
>Suggestions?  If you can help, please call, as this is needed to bypass
>a critical failure in a client's Internet Connection.
>
>Otherwise, due to their apparent lack of support, I will have to take
>this back to the store and get a different card (recommendations
>appreciated).
>
>Thanks and regards,
>Steve
>
>--
>Java/J2EE Developer/Integrator
>Co-Chair, Dallas/FortWorth J2EE Sig
>214-724-7741
>
>
>
>_______________________________________________
>https://ntlug.org/mailman/listinfo/discuss

Jay Urish       W5GM            Systems/Network Engineer
Unixwolf Enterprises    972.691.0125    972.965.6229

http://www.unixwolf.net         AIM:jayurish