[NTLUG:Discuss] OT: ATA Drive Question

[BBBB]

----- Original Message ----- 
From: "william jones" <wljonespe at verizon.net>
To: "NTLUG Discussion List" <discuss at ntlug.org>
Sent: Friday, December 01, 2006 2:38 PM
Subject: Re: [NTLUG:Discuss] OT: ATA Drive Question


> ----- Original Message ----
> From: BBBB <Brad.List at Thingbuilder.com>
> To: NTLUG Discussion List <discuss at ntlug.org>
> Sent: Friday, December 1, 2006 2:21:43 PM
> Subject: [NTLUG:Discuss] OT: ATA Drive Question
>
>
> I purchased a used IBM Netvista computer with a 20 gig ATA drive
(according
> to the part number).
> When using ubuntu's disk partitioner or using Partition Magic, I only see
10
> gigs.
> If this is in fact a 20 gig drive, How do I make the other 10 gigs
visible?
>
> Thanks,
> Bradley
>
> Bradley,
>
> I had a similar problem with a flash drive.  The missing half turned up in
another directory.  It was not visible to the partitioner as an ordinary
partition because it was formatted as Linux swap.  I use it for backup,
readable by Linux but not by Bill's bloatware.  The other half, which was
always visible, is formatted vfat32, readable by all.  Admittedly, there are
problems that will make half of a disk unreadable, such as a bad platter or
a bad reading head.  I wish you good fortune.
>
> William L. Jones.
>

Thanks, William. I suppose the drive could be defective but if it was a swap
partition, wouldn't it have shown up in the Ubuntu installation partitioner?
If I make a swap
partition, it is visible there.

Bradley